The Armourguard F1 is an industrial insulated roller shutter constructed from a twin skin steel lath injected with CFC free foam insulation.
These insulated industrial doors are manufactured from two skins of a solid 100mm flat galvanised steel section.
The F1 insulated door uses a continuous nylon end locking system and a weather proof profile that is incorporated on to the bottom section to create a seal that increases its reliability and performance.
A brush strip can be used at high level to reduce air flow between the lintel and the roller shutter head plate. Glazed panels can also be incorporated into the roller shutter lath.
• Wind Load Tested BS EN 13241-1:2003 (class 5)
• Acoustic value of 28dB reduction (At 1kHz)
• Thermal Value 0.733 W/m2K (through centre of lath)
The Armourguard Industrial F1 is the ideal roller shutter for insulating large industrial openings against heat, noise and energy loss. This product is commonly used on industrial applications where insulation, sound proofing and security is the priority, such as industrial premises loading bay doors, warehouse doors, storage facilities, agriculture premises, barns and industrial units.
100mm x 27mm foam filled
16.5kg square metres
Galvanised bright rolled mild steel, polyester powder coat colours are available.
0.91mm bright spangle galvanised pressed steel coil casing available in various different designs to suit individual circumstances.
Overall height (top of box)
Up to 3000mm box size 400mm
Up to 4000mm box size 450mm
Up to 5000mm box size 510mm
Galvanised steel standard but these industrial doors are also available in a ranger of polyester powder coat colours.
Standard guide rails are 90mm x 32 x 3mm galvanised steel. Double sided brush seal and carriers are used on the
guide section to minimise air leakage.
Galvanised steel standard, polyester powder coat colours are available.
Conventional or direct drive industrial motor unit with integral travel limits, thermal cut out, complete with haul chain override for use in the event of power failure. Safety brakes are used to prevent the roller shutter from closing in the event of motor failure inline with EU legislation. Electrical requirements are dependant on usage, further details on request.
A chain override is included to operate the shutter in the event of a power failure. This is only operable from one side. High level hand crank override can be specified if required.
A counter balanced helical spring controlled via hand chain and chain lock to secure the C1 industrial dooor. A double spring unit is incorporated into the barrel assembly inline as a second device to prevent the roller shutter from closing in the event of single spring failure inline with EU legislation.
Electric operation is via a standard push button control. Other controls are available on request. Further safety devices are available, dependant on requirements and operational circumstances.
Product specification may change and it is advisable to consult with HAG technical advisors before specifying or ordering.
HAG operates a policy of continuous improvement.